RE: Electronic/Circuit board experts, what causes this?

RE: Electronic/Circuit board experts, what causes this?

Over the last several years I’ve found too many failed circuit boards on Rheem/Ruud (specifically) gas package units. The solder on the back of the 9 or 12 pin molex plug cracks and the solder disappears. I don’t know if it’s overheating and vaporizing or… The cracking makes sense because package units are out in the weather, I’m in Tucson Arizona where the summers are 120° and winters get down into the 20’s on occasion. I’ve made temporary repairs by squeezing the pins with needle nose pliers long enough to get a replacement board. I could solder them but there’s a bit of liability there.

RE: Electronic/Circuit board experts, what causes this?

I’ve also found the same on Goodman furnaces, and Lennox, but it’s always on the back of the molex plug. Which is typically a safety circuit, or limit.

TimBagnall Junior Tech Asked on March 5, 2018 in Residential HVAC.
Add Comment
6 Answers

Being only in the back of the molex plug, do you guys think it can be from people pushing and pulling to hard on them?

Rookie Answered on March 9, 2018.
Add Comment

Your Answer

By posting your answer, you agree to the privacy policy and terms of service.