RE: Electronic/Circuit board experts, what causes this?

RE: Electronic/Circuit board experts, what causes this?

Over the last several years I’ve found too many failed circuit boards on Rheem/Ruud (specifically) gas package units. The solder on the back of the 9 or 12 pin molex plug cracks and the solder disappears. I don’t know if it’s overheating and vaporizing or… The cracking makes sense because package units are out in the weather, I’m in Tucson Arizona where the summers are 120° and winters get down into the 20’s on occasion. I’ve made temporary repairs by squeezing the pins with needle nose pliers long enough to get a replacement board. I could solder them but there’s a bit of liability there.

RE: Electronic/Circuit board experts, what causes this?

I’ve also found the same on Goodman furnaces, and Lennox, but it’s always on the back of the molex plug. Which is typically a safety circuit, or limit.

TimBagnall Junior Tech Asked on March 5, 2018 in Residential HVAC.
Add Comment
6 Answers

Very common on Trane as well. Saw a few that will give you a 3 flash open PS, but the voltage isn’t even getting to the PS from the board due to a solder joint

Rookie Answered on March 6, 2018.
Add Comment

Your Answer

By posting your answer, you agree to the privacy policy and terms of service.